Category: Two Phase Separator Sizing

Two Phase Vertical Separators Sizing

{0 Comments}

In vertical separators, a minimum diameter must be maintained to allow liquid drops to separate from the vertically moving gas. The liquid retention time requirement specifies a combination of diameter and liquid volume height. Any diameter greater than the minimum required for gas capacity can be chosen. Figure 4-15 shows the model used for a […]

Read More…

Two Phase Horizontal Separators Sizing

{0 Comments}

For sizing a horizontal separator it is necessary to choose a seam-toseam¬† vessel length and a diameter. This choice must satisfy the conditions¬† for gas capacity that allow the liquid drops to fall from the gas to the liquid volume as the gas traverses the effective length of the vessel. It must also¬† provide sufficient […]

Read More…