Tags: Treaters

Treaters Design Procedure

{0 Comments}

In specifying the size of a treater, it is necessary to determine theĀ  diameter (d), length or height of the coalescing section (Leff or h), and treating temperature or fire-tube rating. As we have seen, these variables are interdependent, and it is not possible to arrive at a unique solution for each. The design engineer …

Read More…

Treaters Water Droplet Size

{0 Comments}

In order to develop a treater design procedure, the water droplet size to be used in the settling equation to achieve a given outlet water cut must be determined. As previously mentioned, it would be extremely rare to have laboratory data of the droplet size distribution for a given emulsion as it enters the coalescing …

Read More…

Treater Retention Time Equations

{0 Comments}

The oil must be held at temperature for a specific period of time to enable de-emulsifying the water-in-oil emulsion. This information is best determined in the laboratory but, in the absence of such data, 20 to 30 minutes is a good starting point. Depending on the specific properties of the stream to be treated, geometry …

Read More…

Treater Settling Equations

{0 Comments}

The specific gravity difference between the dispersed water droplets and the oil should result in the water “sinking” to the bottom of the treatment vessel. Since the oil continuous phase is flowing vertically upward in both vertical and horizontal treaters previously described, the downward velocity of the water droplet must be sufficient to overcome the …

Read More…

Horizontal Treaters

{0 Comments}

For most multi-well situations horizontal treaters are normally required. Figure 6-10 shows a typical design of a horizontal treater. Flow enters the front section of the treater where gas is flashed. The liquid falls around the outside to the vicinity of the oil-water interface where the liquid is “water washed” and the free water is …

Read More…

Vertical Treaters

{0 Comments}

The most commonly used single-well lease treater is the vertical treater as shown in Figure 6-8. Flow enters the top of the treater into a gas separation section. Care must be exercised to size this section so that it has adequate dimensions to separate the gas from the inlet flow. If the treater is located …

Read More…