Horizontal Two Phase Separator

Separators are designed in either horizontal, vertical, or spherical configurations. Figure 4-1 is a schematic of a horizontal separator. The fluid enters the separator and hits an inlet diverter causing a sudden change in momentum. The initial gross separation of liquid and vapor occurs at the inlet diverter. The force of gravity causes the liquid droplets to fall out of the gas stream to the bottom of the vessel where it is collected. This liquid collection section provides the retention time required to let entrained gas evolve out of the oil and rise to the vapor space. It also provides a surge volume, if necessary, to handle intermittent slugs of liquid. The liquid then leaves the vessel through the liquid dump valve. The liquid dump valve is regulated by a level controller. The level controller senses changes in liquid level and controls the dump valve accordingly.

The gas flows over the inlet diverter and then horizontally through the gravity settling section above the liquid. As the gas flows through this section, small drops of liquid that were entrained in the gas and not separated by the inlet diverter are separated out by gravity and fall to the gasliquidinterface.

Some of the drops are of such a small diameter that they are not easily separated in the gravity settling section. Before the gas leaves the vessel it passes through a coalescing section or mist extractor. This section uses elementsof vanes, wire mesh, or plates to coalesce and remove the very small droplets of liquid in one final separation before the gas leaves the vessel.

The pressure in the separator is maintained by a pressure controller. The pressure controller senses changes in the pressure in the separator and sends a signal to either open or close the pressure control valve accordingly. By controlling the rate at which gas leaves the vapor space of the vessel the pressure in the vessel is maintained. Normally, horizontal separators are operated half full of liquid to maximize the surface area of the gas liquid interface.

Leave a Reply

Your email address will not be published. Required fields are marked *